P34AE
A Camshaft Position Actuator Position Sensor A Circuit Low Bank 1
Cam actuator A position sensor on bank 1 signal voltage below expected range. The camshaft position sensor identifies which cylinder is on the compression stroke — without it the ECM cannot run sequential injection or coil-on-plug ignition correctly.
- Check engine light: Yes
- Emissions related: Yes
- Repair difficulty: medium
Symptoms
- Check engine light on
- Power loss especially in mid-rpm range
- Possible rough idle or stalling
- Increased fuel consumption
Common causes
Ordered by how often each turns out to be the cause.
- Signal wire shorted to groundCommon
- Connector pins corroded - high contact resistanceLess likely
- Harness chafing through insulationLess likely
Parts involved
- Cam Actuator A Pos Sensor B1
- Sensor Wiring
P34AE is a generic OBD-II code defined by SAE J2012. Exact wording and diagnostic procedure vary by manufacturer and model. Code definitions are drawn from the public-domain OBDex dataset; the workshop notes are our own.