Shopping cart

  • Warehouse 6, Altay, Al Khawaneej, Dubai
Appointment

P0020 – Camshaft Position Actuator Circuit (Bank 2)

shape_2
Post By Rstwerks

Description

The P0012 code indicates that the Camshaft Position Timing for Bank 1 is more retarded (delayed) than the PCM expects. This typically occurs in vehicles equipped with Variable Valve Timing (VVT) systems. When the timing is “over-retarded,” it means the camshaft is staying in a retarded position longer than it should, leading to incorrect valve timing. This can result in poor engine performance, rough idling, and other drivability issues.

  • Bank 1 refers to the side of the engine that houses Cylinder 1.
  • This issue usually affects the intake camshaft timing.

Symptoms

      • Rough or unstable idle
      • Poor acceleration or reduced engine performance
      • Increased fuel consumption
      • Engine stalling or hesitation
      • Engine misfires
      • Check engine light (CEL) illuminated
      • Reduced power mode (limp mode)
      • Possible engine knocking or ticking noise

    Common Causes

        • Faulty camshaft position actuator (VVT solenoid)
        • Wiring issues such as short circuits, open circuits, or loose connections in the camshaft actuator circuit
        • Dirty or low engine oil affecting VVT system performance
        • Faulty camshaft position sensor
        • Oil control valve (OCV) malfunction or clogging
        • PCM failure (rare)

      Seriousness of the Issue

      • Moderate to High: If left unresolved, the P0020 code can lead to poor engine performance and reduced fuel efficiency. Prolonged driving with this condition may cause further damage to the camshaft actuator or other engine components, resulting in expensive repairs. The vehicle may enter limp mode to limit engine power and prevent damage. Timely diagnosis and repair are recommended.
       

      How to Fix

        1. Inspect the camshaft position actuator (VVT solenoid) for damage or malfunction. Clean or replace as necessary.
        2. Check the wiring and connectors related to the camshaft position actuator circuit for signs of damage, corrosion, or disconnection. Repair or replace damaged wires or connectors.
        3. Change the engine oil and filter if it is dirty or contaminated. Clean oil is essential for proper VVT operation.
        4. Test the camshaft position sensor to ensure it is functioning correctly. Replace it if faulty.
        5. Clean or replace the oil control valve (OCV) if it is blocked or malfunctioning.
        6. Check oil passages for blockages that may be preventing proper oil flow to the VVT system.
        7. If the issue persists, check the PCM for faults, and reprogram or replace it if necessary.

      Proper diagnostics of the VVT system and electrical circuit are essential to avoid unnecessary part replacements and to restore the engine’s performance.

      Comments are closed